How many SSDs are located in each XtremIO storage controller?

A. 0

B. 1

C. 2

D. 4

In an XtremIO environment, what is the minimum number of data bits that can be different in an incoming 8 KB block before the data is given its own unique fingerprint value?

B. 2

C. 4

D. 8

Which RJ45 Ethernet interface should be used to initially configure an XtremIO storage controller?

A. RJ45 Ethernet interface 1

B. RJ45 Ethernet interface 2

C. RJ45 Ethernet interface 3

D. RJ45 Ethernet interface 4

Which port should be opened between the XMS and the FTP server when deploying a Connect- Home integration using FTPS?

A. 25

B. 442

C. 989

D. 8080

Which XMCLI command is used to determine if a FC initiator is registered but not part of an initiator group?

A. show-discovered-initiators-connectivity

B. show-initiators-connectivity

C. show-initiator-groups

D. show-initiators-performance

An XtremIO storage array reports an overall efficiency of 30:1. Which combination of Deduplication Ratio (DR), Compression Ratio (CR), and Thin Provisioning Saving (TPS) would achieve this efficiency?

A. DR = 2.5:1; CR = 4.0:1; TPS = 30%

B. DR = 3.0:1; CR = 2.0:1; TPS = 50%

C. DR = 4.0:1; CR = 2.5:1; TPS = 70%

D. DR = 5.0:1; CR = 2.0:1; TPS = 66%

The XtremIO Management Server (XMS) reports that an XtremIO cluster has a compression ratio of 4.1:1 and a deduplication ratio of 1.3:1. What is the reported data reduction ratio?

A. 2.8:1

B. 3.2:1

C. 5.3:1

D. 5.4:1

What is a characteristic of XtremIO iSCSI connectivity?

A. Port 3260 must be used

B. VLANs must be in the 0-127 range

C. iSCSI ports must be on the management port subnet

D. Only two iSCSI ports can be connected to a single host

What is a characteristic of XtremIO initiator groups?

A. Contains only FC initiators or only iSCSI initiators

B. Contains initiators from only one host

C. Must contain all initiators from a host

D. May contain only two initiators from any host

Which three performance parameters can be monitored using the XtremIO GUI?

A. Bandwidth, IOPS, Latency

B. Bandwidth, IOPS, Utilization

C. Utilization, IOPS, Service Time

D. Latency, Bandwidth, Response Time