Want to pass your PowerEdge Specialist for Implementation Engineer DES-4121 exam in the very first attempt? Try Pass2lead! It is equally effective for both starters and IT professionals.
VCE
A system administrator needs to install OpenManage Server Administrator on 200 servers. What is the quickest way to meet this requirement?
A. Use the Lifecycle Controller to install OpenManage Server Administrator on each server.
B. Install OME and push OpenManage Server Administrator to all 200 servers.
C. Use Microsoft utilities to automate the deployment of OpenManage Server Administrator.
D. Download OpenManage Server Administrator from Dell.com and install on each server.
A user installed OME on a PowerEdge R640 server. OME has discovered and is currently monitoring another 30 remote PowerEdge 14G servers. Each server has the following configuration:
2x CPUs 384 GB RAM 6x 1TB drives in a RAID 6 virtual disk No hot spare drive PERC vFlash iDRAC9 Express license
At 9 PM on Monday evening, one of the remote servers has a disk failure but stays operational. The administrator monitoring OME does not find out about the issue until 5 PM in the following Friday. They place a support call to investigate why OME was not informed about the disk failure before then.
What is the reason for this issue not being reported to OME?
A. Remote servers are not configured with OME as the trap destination address. OME discovered the issue during a routing status check which is configured to run at 5 PM every Friday.
B. OME only updates its alert database at 5 PM every Friday.
C. Remote servers are not configured with OME as the trap destination address. OME was informed of the issue when remote servers sent alerts at 5 PM Friday.
D. Remote servers need to have the iDRAC Enterprise license installed to be able to send alerts.
A technician needs to use the iDRAC GUI to roll back a diagnostics firmware revision on a server that was updated four weeks previously. However, the replaced version cannot be found in the Firmware Rollback section on the iDRAC GUI.
What could be the issue?
A. Diagnostics firmware revision is part of the Lifecycle Controller firmware so the Lifecycle Controller must be updated first
B. Rollback feature was not enabled in iDRAC Settings
C. Firmware can only be rolled back within a week of being replaced.
D. Diagnostics firmware is not supported in the Rollback feature.