The following modes of operation are supported with the Network login feature. (choose all that apply)

A. Secure mode

B. Campus mode

C. Quick Mode

D. ISP mode

According to accompanying diagram and ACL configuration it is possible to telnet from host A to any of the switch IP addresses.

A. True

B. False

DVMRP is similar to OSPF in that it is Link State based.

A. True

B. False

The Skew time in VRRP is used to ensure that two back-up routers do not switch to master state at the same time an case of a fall-over situation.

A. True

B. False

In OSPF, when you configure an Extreme switch with router priority of 0, what happens?

A. The router becomes a Backup Designated Router

B. The router becomes a Designated Router

C. The router will not participate in the DR election algorithm

D. Nothing because router priority 0 is the default setting for router priority

When configuring a Summit 5i for OSPF routing, it is recommended to manually configure the OSPF router-id rather than setting the router-id set to automatic.

A. TRUE

B. FALSE

In general IS-IS allows routing of both IP and OSI packets. What type of Implementation does ExtremeWare support?

A. IP only

B. OSI only

C. Dual

D. None of the above

_________is an ESRP option that allow(s) multiple VLANs to be controlled by a single instance.

A. ESRP domains

B. ESRP groups

C. ESRP host-attach

D. None of these

What is true about the StpdID?

A. The StpdID must be equal to one of its member VLAN ID's.

B. The StpdID may not be equal to one of its member VLAN ID's.

C. The StpdID may not be equal to any VLAN ID.

D. It does not matter if the StpdID is equal to a VLAN ID.

Re-establishment of a previously pruned network branch is not supported by DVMRP.

A. True

B. False